Manually configuring a grandstream with android firmware
Access the phone by navigating to its ip address
Open maintenance copy these settings:
Under provision copy these settings:
At the end of the screen hit save and then reboot the phone
Related Articles
Manually configuring a grandstream device
You will need to get access to the phone's web GUI, this is done by navigating to the IP address of the phone on a computer that is connected to the same network as the phone. Once at the web GUI you will need to log in with either the ...
Grandstream GXW410X PSTN Gateway Setup
Prerequisites Reseller or Higher scope Access to create a SIP Trunk GXW410x with Firmware version 1.4.1.5 Device can not be added like a normal device, support will need to manually add the device. Account Setup The Gateway requires a SIP Trunk ...
Grandstream P-Codes
Grandstream P-Codes P-Code Retrieval One of the most common ways to generate a P-Code Template is to configure the phone using the WebUI and exporting the phones configuration, which can be found under Maintenance > Upgrade and provisioning. If you ...
Grandstream GDS3710 Setup
Prerequisites Access to the GDS3710 webgui Office Manager or higher user scope Manual device credentials found here This KB will go over how to setup basic functionality of the Grandstream GDS3710 video door system. Please use extension range ...
Grandstream GXW4501 Setup
Prerequisites SIP Trunk credentials Description This document describes how to link a legacy PBX (e.g. Nortel, Shoretel, Cisco, Avaya, etc...) to a Grandstream PRI Gateway, the gateway then connects to Unitedcloud via a SIP Trunk and can process ...