Manually configuring a grandstream device

Manually configuring a grandstream device

You will need to get access to the phone's web GUI, this is done by navigating to the IP address of the phone on a computer that is connected to the same network as the phone.

Once at the web GUI you will need to log in with either the manufacturers(admin/admin) default credentials or the supplier's credentials.

Now that you are logged in, navigate to Maintenence then select the provisioning option.



Once you are in here, you just need to change the Config Server Path to:

phones.iplogin.ca/cfg

Select the HTTP Radio, or dropdown

- And change the Provision Via to Https

Now you just need to press save and power cycle the phone


    • Related Articles

    • Setup Manual or Softphone Device

      Unsupported phones and many unified communication softphones require manual configuration. The article below covers how to set up an account in the portal to be entered into the devices configuration.  All Manually setup devices need to have their ...

    • Grandstream GDS3710 Setup

      Prerequisites Access to the GDS3710 webgui Office Manager or higher user scope Manual device credentials found here This KB will go over how to setup basic functionality of the Grandstream GDS3710 video door system.  Please use extension range ...

    • Grandstream HT81x Setup

      Prerequisites Access to the HT81x webgui Office Manager or higher user scope Manual device credentials found here SIP Trunk credentials will require a partner account or support to assist.  This KB will go over how to setup basic functionality of the ...

    • Bria Desktop (Counterpath) Setup

      Get started with your Bria Desktop softphone app Prerequisites If you have not already created a manual device on the Manager Portal. Either a Solo or Teams account setup at counterpath.com Manual device credentials from this KB ...

    • Grandstream GXW410X PSTN Gateway Setup

      Prerequisites Reseller or Higher scope Access to create a SIP Trunk GXW410x with Firmware version 1.4.1.5 Device can not be added like a normal device, support will need to manually add the device. Account Setup The Gateway requires a SIP Trunk ...